Internal Chip: F1T-D2I FT232RNL
Length:1.8M
Supported OS : 11/10/8.1/8/Vista/7/XP/.etc , OS ,Linux
Internal EEPROM with user writeable area.
Pinout:TXD,RXD,VC,GND ,CTS,RTS,DTR,DSR
VIRTUAL COM PORT (VCP) Drivers are available for the following Operating Systems (OS):
- 11,10,8.1,8,Vista,7,XP
- 98, 98SE, ME, 2000, - Server 2003, XP, Server 2008 and server 2012 R2
- XP Embedded
- CE 4.2, 5.0 and 6.0
- OS 8/9, OS-X
- Linux 2.4 and greater -(J2xx / D2xx only)
Virtual COM Port (VCP) drivers cause the USB device to appear as an additional COM port available to the PC. Application software can access the USB device in the same way as it would access a standard COM port.
Please also refer to the Installation Guides documents for details on how to install the drivers.
Typical Applications
USB to serial RS232 level converter.
Upgrading peripherals to USB.
Interface Microcontroller UART or I/O to USB.
Interface FPGA or PLD to USB.
USB Instrumentation PC interface.
USB industrial control.
USB password protected file transfers.
About FT232RNL Chip:
The F1T-D2I FT232RNL Chip Features:
1. Single chip USB to asynchronous serial data transfer interface.
2. Entire USB protocol handled on the chip. No USB specific firmware programming required.
3. Fully integrated 1024 bit EEPROM storing device descriptors and CBUS I/O configuration.
4. Fully integrated USB termination resistors.
5. Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.
6. Data transfer rates from 300 baud to 3 Mbaud(RS422, RS485, RS232) at TTL levels.
7. 128 byte receive buffer and 256 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.
8. F1T-D2I's royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers the requirement for USB driver developme