【Easy to Install】: Take out the original car antenna, connect the copper wire of the shark fin antenna with the original car antenna, tear off the adhesive protective paper, stick it in position, and press for a few seconds to complete the installation. No need to drill, no damage to the car. Clean and dry the car before installation, so that the adhesion is maximized and it does not fall off easily.

【Good Replacement】: Automotive finfish fin antennas can replace your original antenna. It can be used as a signal amplifier, enhance the vehicle's signal through the internal FM/AM connection cable while driving, have better reception

【Enhance Signal】: Dynamic lines, reduce wind resistance, use reinforced signal receiver, making signal stable and strong. The original receiving line is too long, which affects the appearance of the car, and the signal is not continuous, which will bring a bad mood. After installation, there is no need to worry about these problems. A variety of colors can be selected, and the shark fin antenna can be selected according to the color of your car.
Please note:

-Before pasting, please keep the installation location clean and dry.

What's difference before and after the shark fin antenna installation?

-Before installation, the receiving line is too long. Not only does it affect the appearance, but the wind resistance is large, which increases fuel consumption.

-After installation, raise the slope and reduce wind resistance. Unique shark fin design for your vehicle's aesthetic appeal.