EK-Loop OmniLink Pump SATA PWM D-RGB Signal Splitter cable allows users to connect D-RGB LED devices, SATA powered pumps and 4-Pin PWM fans to the OmniLink cable harness using their standard connectors. The OmniLink cable allows for an easy transmission and distribution of +12V and +5V Power; PWM, TACHO, and D-RGB signals. The cable features a stylish black ribbon cable for easy build integration and cable management. Technical Specifications: - Molex Micro-fit 3.0 8-pin Male connector to: 1x Molex Micro-fit 3.0 8-pin Female Connector 1x SATA Power Female Connector (Ground, +12V) 1x 4-Pin PWM 2 Fan Male Connector (Ground, +12V, TACHO, PWM) 1x 3-Pin D-RGB LED Female Connector (+5V, Data, Blocked, Ground) - Cable length: 250±10mm - Color: Black - Power Wire gauge: AWG20 - Signal Wire gauge: AWG22 - Molex Micro-fit Connector current rating: 8.5A - Power Cable current rating: 8A - Signal Cable current rating: 6A EK-Loop OmniLink Pump SATA PWM D-RGB Signal Splitter cable is compatible with all EK OmniLink products, PWM fan/pump speed control technology, and all popular D-RGB sync technologies from major motherboard manufacturers (if the header is supported). Only the PWM 2 signal is accessible with this OmniLink splitter cable, which is intended to control the pump speed. For the PWM2 signal to work, the the EK-Loop OmniLink 6-Pin Power (dual PWM) cable must also be used. It's primarily used for adding a distro plate/combo into omnilink and consolidating all of the connectors into the harness. For PWM2 signal to work, EK-Loop OmniLink 6-Pin Power (dual PWM) cable must be also used. Model: 3831109897508