The EZ-Bridge LT2+ is a high power 25dBm (316mW) outdoor wireless bridge system operating in the 2.4GHz unlicensed frequency spectrum providing real world throughput up to 100 Mb/sec . It complies with the 802.11gn standards to insure interoperability . The EZ-Bridge LT2+ creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight. It supports VOIP, VPN, multiple MAC addresses and DHCP across the wireless link . It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access . Multiple EZ-Bridge LT2+ units can be connected in a mesh configuration to allow interconnecting more than two sites . With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security. Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power inserters . The units will automatically find their peer and create a secure wireless network link . If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that needs to be loaded to the computer. The EZ-Bridge LT2+ comes complete with all the electronics that are needed for a point to point wireless network bridge installation ; including 2 powerful 14dBi 802.11gn MIMO antennas with built-in high power electronics , Bracket Kits which accommodate pole or wall mounting and Cat5e rated 24V POE (Power Over Ethernet) power inserters .