Fitment:
Fit for Detroit Series 60 engine
Replacement Part Number:
J-46904 J-48824
Specification:
Color: Black
Material: Advanced blackened hardened steel process
Using Instruction:
1. Install the injector tube repair tool (J-46904 or J-48824) to the injector tube, ensuring that the tabs are engaged and the tool is in place
2. Turn the tool counterclockwise to remove the injector tube and record the gasket position
3. If using the J-48824, turn the center bolt to spread the fingers on the end of the tool
NOTE:
When removing the injector tube, check the bottom and hole for gaskets. If the old tube had a gasket and the tube is being replaced, the new tube will also need a gasket. Gaskets are used to adjust the height of the injector cup after the cylinder head is re-grinded