For customer convenience, We have written the new 4.2 pi-star firmware in the tf card.
We have done most settings for pi-star in the TF card.
You will find it more easier to get it work.
1.we have set it to Simplex mode.
2.we have choose OLED type 3
3.we have choose STM32 GPIO type
4.we have set a tmp wifi parameters，ssid:m100,password:abc12345.
5.you do not need to set tx and rx offset, default 0 is ok.
First time to use,Suggest to Connect the hotspot to the router by a network cable directly. So you do no need to set the wifi.
All you need to set are:
1) callsign
2) dmr id
3) BM hotspot security
Support:DMR,YSF,D-STAR,P25,
Support:Duplex mode,Simplex mode.
WIFI SSID:Need the 2.4GHz SSID as the Pi Zero W doesn't support 5.8GHz
Software:Pi-Star
Power supply: Mobile charger or a USB cable connected to your computer or laptop.
The Hotspot will also work mobile in your vehicle if you tether it to your mobile phone network.
Shell:Acrylic Shell,See clearly.
Antenna: one antennas for UHF
LEDs: on board leds to show status,
Screen:Two Colors Oled, Yellow and Blue.
Note: All designs will be contributed on MMDVM open source project.
Package lists:
1. Hotspot x1 (With Raspberry Pi Model 2B assembled)
2. OLED display x1 (installed on board)
3. 8G TFT card x1
4. Wireless wifi module x1
5. Acrylic Shell x1 (assembled)
6. 433Mhz UHF Antenna x1
7. Usb Cable x1
8. User Manual Paper x1