HOMEIDOL 10Pcs Long Carbide Burr Set 1/4" Shank Die Grinder Bits, Tungsten Carbide Rotary Burr Set for Dremel Bits, 4"(100mm) Long Rotary Files Tungsten Carbide Rotary Burr Set, Carbide Drill Bits for Metal Wood Carving Engraving Deburring
1/4 inch long carbide burr set with a total length of approximately 100 mm can be used for deep rust removal, grinding, drilling, and other tasks. 3 different head diameters (6mm, 8mm, 10mm) to meet most of your design needs in handmade crafts. This compatible with dremel bits can solve the problem of grinding areas that are too deep or difficult to reach.
Please note that when using 4 inch long carbide burr set 1/4 shank, the tool must be securely clamped and inserted the shank of bits to the bottom of clamping is optimal! The rotary tool must be controlled within the range of 3000-6000 RPM. At all times when the tool is in operation, or when it is being turned on or off, the tungsten carbide burr drill bits must remain in contact with the workpiece. Failure to follow this procedure may cause the burr shank to bend and increase the risk of injury! If continuous contact between the drill bit and the workpiece cannot be guaranteed, the maximum idle speed should not be exceeded. Maximum idle speed without contact with the workpiece: 5000 RPM.
1/4 inch (6mm) shank for dremel carbide bits are good choices of DIY carving, engraving, and polishing. Easy to use and essential for woodworkers and metal enthusiasts who clean welds or work with metal often. Excellent for fine detail work, cutting, engraving, carving, touch-up and finishing. The 1/4 inch shank carbide burr set is also an ideal gift for woodcarvers
Please wear protective equipment such as goggles, masks, and gloves when using this product!