الاجهزه الالكترونيات الامريكية قد تحتاج الى محمول فولت من ١١٠ الى ٢٢٠.قد تحتاج إلى محول كهرباء
مميزات خاصة
Materials: The main materials used are imported POM plastic (also known as polyoxymethylene resin, steel-like material). The appearance is exquisite and the wear resistance is excellent. The guide wheel bearings use stainless steel high-speed bearings. All the metal parts of the water blowers (bearings, spring clips, brackets, screws and nuts, guide wheel fixing plates) are made of stainless steel and will never rust, ensuring long-lasting durability.
Practical Design: It adopts scientific fluid principle in the design, which can quickly blow off the surface moisture of the wire with high efficiency and low noise. Water blowing device is widely used because of its energy saving, environmental protection, economical and practical.
Function: This water blowing device is widely used due to its energy-saving and economic features, and is particularly suitable for the wire and cable production industry. The design adopts scientific fluid principles, which can quickly blow off the moisture on the surface of the raw materials, achieving the effects of saving gas, high efficiency, and low noise. The linear speed of the single-stage water blowing device can reach 1000m/min, and that of the double-stage water blowing device can reach 1500m/min.
Easy to Operate: The main body is of a detachable flap type, The knotting and bulging of the wire can pass smoothly, ensuring the continuity of production. Guide wheels (plastic wheels and all-ceramic wheels) are installed at the front and back, which can be adjusted up, down, left and right. This prevents the wire from being scratched when passing through the blowing device.
Easy to install: Installation This product comes with an installation bracket. the bracket can be adjusted in height and angle. It can be installed in the sink (with a cover) or the collection box. First, select a suitable fixed position. Drill two 8mm holes using an electric drill, secure the fixing base with screws, insert the air pipe (the intake pipe is 10mm), adjust the height and center position of the front and rear rollers, and then turn on the air to use.
وصف
1. The exhaust volume of the air compressor should not be less than 0.6 cubic/min, and the supply pressure should not be lower than 0.55 MPa. Otherwise, the water filtration effect will be affected.
2. Air compressor selection: Air compressors come in screw type and piston type. Generally, it is best to choose the screw type air compressor. The power of the two types of air compressors should not be lower than 5.5/7.5 (KW/P).
3. Water blower selection: The maximum diameter × 1.5 - 2 times = the actual required inner hole of the water blower. The coefficient is not fixed and should be adjusted appropriately according to the actual usage situation. An inner hole that is too large will waste air and the effect is not good. An inner hole that is too small will scratch the wire, and the wire knots and bulges cannot pass smoothly.