Relays / Phase Monitoring Relays
General
EM-06-DIN Multimeter are designed to display 3 phase current, voltage and frequency.
Usage and Working Principle
Make the connections according to the diagram. Connect the current before electric charges to be connected to the
Current dont sense voltages which connected before them. Apply max 5 A the current inputs. Press the menu button once the energy given to the device.Please enter the current value that you are using by pressing up down buttons, to save it please press menu button once again. If the current transformer value is over 1000/5
Under normal working circumstances when the current value is over 1000A KA led that belongs to that phase gets on. You can observe the current values at the sytstem trough the second display group at the right side of the screen.
You can see the frequency between phase and phase, phase and neutral at the first display group. When the voltage values is shown (V) led gets on. While pressing the up button ,phase-phase range can be seen.When the phase-phase values is shown you can see the leds on phase phase. While pressing theup buttons you can see the frequency value and Hz led gets on.
Phase Sequence: If the phase sequence is reverse you can see the (X) led gets on which take place in the 1st display group.
Maintenance
Switch off the device and release from connections. Clean the trunk of device with a swab. Don't use any conductor or might damage the device.
Make sure device works after cleaning.
Warnings
Please use the device according to the manual.
Don't use the device in wet.
Include a switch and circuit breaker in the assembly.
Put the switch and circuit breaker nearby the device, operator can
reach easily.
Mark the switch and circuit breaker as releasing connection for device.
Specifications
Operating Voltage(Un).......: 85V - 240V AC
Operating Frequency..........: 50/60 Hz.
O