Installation:
IMPORTANT: The filter blocks come with
a cap. Remove the cap before using the
filter and store it for later use. Replace the
cap on the filter to prevent the filter from
drying out during extended periods of
non-use.
1. Fil a clean container with clean water
and soak the replacement water filter in
the water for at least 30 minutes. Tilt the
filter, while under water, so that any air
bubbles can escape from both ends.
2. Remove the water filter from the water.
Cover the holes with either your fingers or
the black caps that came with the filter,
and shake the filter vigorously. Then tap
them lightly on the counter to loosen any
residual manufacturing dust.
3. Screw the new water filter onto the
upper chamber.
4. Return the upper chamber to the
system by placing it onto the lower
chamber.
5. Fil the upper chamber with water and
let it drain into the lower chamber. When
the lower chamber is full, discard the first
batch of water as it may contain residual
manufacturing dust. The system is now
ready for use.