Built-in suction homogenizing blade (internal cutting design) to avoid cross contamination and ensure sample integrity.
Safety protection: All-metal body to prevent leakage, 3-minute automatic shutdown protection to prevent motor overheating.
Technical parameters
Power: 300W | Voltage: 220V/50Hz
Maximum capacity: 1000ml | Weight: 8kg
Dimensions: 300×250×400mm

Operation guide
Installation: Insert the blade into the motor shaft and tighten the fixing screw; clamp the sample container on the magnet holder.
Debugging: Immerse the blade in clean water, start at low speed, and gradually increase the speed to ensure no metal friction noise.
Homogenization: Add the sample (it is recommended to be cut into 5mm small pieces in advance), the blade is 2-3mm away from the bottom of the container, set the speed to start, and the single run is up to 3 minutes.
Cleaning: Remove the blade, rinse with pure water, and then disinfect with alcohol.

Precautions
Do not run without load!
High viscosity samples need to be processed in batches to avoid overloading.
The blade is sharp, please wear protective gloves when operating.

Packing list
1× host
1× long homogenizing blade
1× magnet fixing bracket
1× power cord
1× English manual