Parameter

Capacity: 100Nm
Rated Rotation Speed: 8000 RPM
Shaft diameter: 18mm
Nonlinear: 0.1%FS
Power supply: DC24V
Repeatability: 0.03%FS
Current consumption: Less than 200mA
Hysteresis: 0.03%
Torque output: 4-20mA
Temperature influence of zero point: 0.01%FS/℃
Speed ​​output: 120 / 60 pulses/rev
Reaction performance: 1kHz
Rated Rotation speed: 8000rpm
Load resistance: more than 2kΩ
Maximum rotation speed: 15000rpm
Signal delay: 2.6ms
Maximum torsion angle: 2.60x10rad(0.149°)
Allow overload: 150%FS
Operating temperature range: -10 ~ + 50℃
Vibration natural frequency (rotor part): 19.4kHz
Torque constant: 3.85x10Nm/rad
Accuracy: 1/1000 or higher
This sensor supports current and voltage output.

If a 120-line code disk is used, the acquisition speed is 25 times per second at a rotation speed of 12.5RPM or above.
Measurement performance: 24-bit AD acquisition chip, acquisition speed 1200 times/second.
Torque value display range -99999-99999, speed value display range 0-99999.
Communication: 485 communication port can execute Modbus-RTU protocol ASCII active upload HEX active upload protocol.
Transmission: 4-20mA, 0-10V (optional)
Key: 3 independent key operations.
Power supply: DC 24V (±10%), 0.2A. Maximum voltage 27.5V, minimum starting voltage 12V.
Speed ​​output: The output of the shaft body rotates one circle, and the output can be selected as 2000-line encoder or 120, 60 pulses.
Working environment: Temperature: -20-70℃; Relative humidity: ≤85%RH; Avoid strong corrosive gases