ITECHSMT RF-A series reflow oven is mainly for the prototyping and small production of SMT products such as desktop solder reflow machine. The product uses high efficiency infrared heating elements and distributed thermocouple temperature measurement device. Through the microcomputer's precise control, the temperature of the reflow oven curve control can be more accurate, and the temperature of the SMT reflow plane can be more uniform. The SMD reflow furnace is fully able to adapt to a variety of different alloys and lead-free solder reflow requirements. Its temperature curve precision can be adjusted; in addition, this PCB oven also has automatic fault detection alarm and other functions. This product has a variety of applications such as reflow soldering, repair, drying and so on. It's suitable for small quantities of SMT electronic products production, test research, electronic product development, school training courses and other units. This operating software is English operating system developed independently by ITECH. The structure of the circuit adopts high effciency, convenient and integrated design, adopts aluminum silicate high temperature environmental protection heat preservation cotton, has good heat preservation effect, and improves and upgrades in aspects of performance, structure and operation. The outer shell of the machine is made of high quality cold-rolled sheet by electrostatic spraying, and the inner tank is made of 201 stainless steel. Durable, the inside ofthe case isfilled with high-quality thermal insulation cotton to effectively save heat loss and reduce thecase temperature. The single-chip microcomputer control system is independently developed by our company.

Specification：
○Name: Infrared and Hot Air Convection Reflow Oven
○Model: RF-A250
○Power: 1600W
○Temperature Range: Max 572℉
○Operating Mode: Offline key mode / Online PC mode
○Gross Weight: 46Lb
○Effective Soldering Area: 10" x 8"
○Drawer Size: L11.81" x W9.84" x H1.18"
○Outline Size: L16.73" x W15.74" x H12.28"

Attention:
○We intentionally make the drawer area larger than the soldering area, because the temperature at the edge of the drawer will be 59℉ lower than the setting.
○Of course, you can take the edge of the drawer as the soldering area, as long as you make sure that the temperature meets the requirements. The soldering area is about 4cm from the edge of the drawer, please pay attention to distinguish!
○After use, don't switch off the power instantly. Make sure the machine is cooling down sufficiently before switching off.

Packing List:
○1 x Infrared & Hot Air Convection Reflow Oven
○1 x Heat Resistant Exhaust Pipe(Dia.-4", Length-59")
○1 x Exhaust Pipe Buckle
○1 x Power Cable
○1 x DB9 Connector Wire for PC
○1 x Fuse
○1 x Instruction Manual
○1 x Software(Pls contact us to get it)