Filters
Product Features:
1. Light and compact structure, easy to install and use;
2. Press-in self-locking mechanism can prevent the set pressure from changing due to external interference;
3. Small pressure loss and high water separation efficiency;
4. Transparent inspection cover allows direct observation of the amount of oil dripping;
5. In addition to the standard form, there is also a low-pressure type available (maximum adjustable pressure 1.0MPa).

Features:
1. The air filter is used to clean the air and can filter the moisture in the compressed air to prevent moisture from entering the device with the gas.
2. The pressure reducing valve can stabilize the pressure of the air and keep the air in a constant state, which can reduce damage to hardware such as valves or actuators due to sudden changes in the air pressure. The filter is used to clean the air and can filter the moisture in the compressed air to prevent moisture from entering the device with the gas.
3. The oil mist device can lubricate the moving parts of the machine body and lubricate the parts that are inconvenient to add lubricating oil, greatly extending the service life of the machine body.
Instructions for use of air treatment parts:
1. There are two ways of filter drainage: pressure difference drainage and manual drainage. When draining manually, it must be drained before the water level reaches the level below the filter element.
2. When adjusting the pressure, please pull up and then rotate the knob before turning it. Press down the knob to position it. Turn the knob to the right to increase the pressure, and to the left to decrease the pressure. When adjusting the pressure, it should be adjusted gradually and evenly to the required pressure value, and should not be adjusted in one step.
3. How to use the oil feeder: The oil feeder uses JIS K2213 oil ( Vg32 or equivalent oil). Please do not fill the cup more than 80% full. The number 0 is the smallest amount of oil, and 9 is the largest amount of oil. It cannot be rotated from the 9-0 position and must be rotated clockwise.

Precautions for using connectors:
1. Make sure that the cut surface of the pipe is vertical, that there are no scars on the outer circumference of the pipe, and that the pipe is not oval.
2. When inserting the pipe, be sure to insert it to the bottom of the joint. Failure to insert the pipe to the bottom may cause air leakage.
3. After the pipe is connected and installed, pull the pipe to confirm that the pipe cannot be pulled out of the joint.
4. Please do not use it for purposes other than fluids.
5. Do not exceed the maximum operating pressure when using it.
6. Do not use it outside the operating temperature range to prevent deformation of the sealing material, which may easily lead to leakage.
7. Do not hit, bend, or stretch artificially to prevent damage.
8. Do not use it in places where metal powder or sand dust is mixed. If debris adheres to it, it may cause malfunction or leakage.
Precautions when disassembling: Use appropriate tools and use the outer hexagonal part of the pipe joint to disassemble the pipe joint. Remove the sealing material adhering to the mating side of the pipe joint. Otherwise, the adhered sealing material may enter the surrounding components and cause failure.