Instructions for use:
1. The base surface must be flat, solid and clean;
2. Use a brush to evenly apply the black rubber coating glue on the treated base surface;
3. To achieve a thickness of 0.6-1.0mm or more, at least three times or more are required;
4. After each layer is applied, it must be slightly dried (preferably without getting your hands wet) before applying the second layer. The direction of application should be perpendicular to the first layer to facilitate better coverage;
5. After drying for 24 hours at normal temperature, the solidified state can also be accelerated by using drying equipment.
Notes:
1. The construction temperature should be between 5-35℃;
2. The waterproof layer is directly exposed for use. It is not recommended to lay tiles or mortar layers;
3. After opening the cover for use, the unused product should be sealed and stored in time to prevent the paint from being contaminated and drying;
4. Please pay attention to the storage of the product in cold areas or under low temperature conditions. The storage temperature of the product should not be lower than 0℃;
5. Please avoid rain during construction. Please take rain protection measures within 48 hours after the construction is completed;
6. It is not suitable for long-term immersion in water, such as pools, swimming pools, etc. When used for roof waterproofing, drainage must be handled first;
7. If it comes into contact with eyes, rinse with water immediately. If you have any discomfort, please seek medical attention immediately.