Technical parameters of FSH-2A adjustable high-speed homogenizer:
Motor speed: 8000-22000 rpm
Rated power: 220W
Rated voltage: 110V
Rated frequency: 60HZ
Adjustment system: knob
Processing capacity: 5-1000ml
Weight: 7KG (15.4LB)
Size: 27x17x40cm (10.6x6.7x15.7in)
Working mode: alternate 5 minutes
Working method: internal cutting tool
Contact material: stainless steel and polytetrafluoroethylene
Working head size:
1212G: diameter 12mm, length 120mm
1218G: diameter 18mm, length 120mm

Warm Note:
1. The instrument should be placed on a horizontal work surface, and the homogenization knives required for installation must be in place. When turning on the power to test the machine, first use a cup or utensil filled with water to submerge the plum blossom knife head in the water, turn on the power switch, and adjust slowly Turn the speed knob to fast and there is no obvious metal friction sound (if there is metal friction sound, turn off the power, loosen the 6M/M clamping screw of the tool, turn the outer fixing sleeve into place at random, and then tighten it) before it can work.
2. Cut the plants or m-i-croorganisms to be tested into small pieces or pieces, put them in the supplied glassware, clamp them in the middle of the magnet bracket (seven-shaped), loosen the 8M/M fixing screws of the fixed motor base, and slowly align them Move the mouth of the vessel down so that the homogenization head is 2-3mm away from the bottom of the vessel, and then tighten the 8M/M screws.
3. After long-term use, the PTFE in the high-speed disperser cutter is a vulnerable part for users to replace. After each work, remove the knives and rinse them with water to dry.