This cupholder by Spyderbands is designed to fit perfectly in the rear storage compartment in the center console of the 2003 through 2009 350Z.

This is a 3D printed component with a textured surface. It has been printed with water and heat resistant PETG material so it will not be affected by beverage condensation or spills. It is designed to fit very tightly and lock in place but can be removed with one hand as needed.

Standard: The circle is 2.7 Inches in diameter designed for most beverages and the square section 3 Inches square intended for a second beverage or compartmentalized storage as needed.

40oz Jumbo: The circle is 3.7 Inches in diameter designed for 40oz containers with 3.6 Inch bases and the square is 4 Inches x 1.9 Inches and perfect to hold your wallet while driving.

This part has been redesigned so it now fits BOTH DE and HR interiors. So it will work in any 350Z 2003-2009

This is a heavily modified version of the original design by skyshadow07 under the Creative Commons - Attribution license.