Motors
1 & 220v 22kw Water cooled ATC ceramic ball bearings
1 22kw Fuling Inverter
ModelGDL802024Z2.2
Voltage:220v
Power:2.2kw
Current: 7.6A
Frequency:800Hz
Rotating speed:24000rpm/30000rpm
Pole number: 4P
Phase number:3
Weight(kg):8KG
Blind rivet:IS020-15° (Parfaite is recommended)
Tool holder:IS020 (Parfaite is recommended)
Rotating direction: Rotate anticlockwise from the shaft extension end
1.The electric main shaft shall be installed at the clamped position; otherwise the bearing will be easily damaged!
2. The main shaft shall entirely stop before the tool changing. The manual tool changing button shall not act during the rotation of the shaft; otherwise it will easily result in the seizure of the shaft!
3. The compressed air shall be clean and dry, and the filter accuracy shall be 0.1 ! Air seal is normally open. It is recommended to use the two-level filter, and the filter accuracy is 0.5 micron/0.1 respectively. The air filter is installed with the self-discharge device.
1: Power line Three-color lines connected with U.V.W phases/yellow and green wires grounded. Temperature controlline 110 therminstor two- phase connected with the temperature-control protector.
2: Cooling water feed Pump lift 8m
3:Pole change and dust removal pressure 0.2-0, 3Mpa (6/4 hoses)
4: Quantity of proximity switchesPole hanging and pole discharge NPN (normally open)N.O. Wiring method of the proximity switch Brown wire connected with +24VDC/the other end connected with the balck wire.
5: Air seal pressure0.1-0.2Mpa (4/2 hoses)
6: Cooling water yielding (2 and 6 ends terminated with 8/6 hoses)
7: Air inlet pressure of the cylinder 0.65Mpa (6/4 hoses)
1. Our Ceramic ball bearings use 4 pcs ceramic ball bearings.
2. Ceramic ball bearings are to high temperatures and low heat, usually 3-5 degrees lower than steel ball bearings during using .
3. Ceramic ball bearings have low