Easily wire and support up to 4 steering wheel buttons while using only one cord while adding a very convenient and usable quick disconnect. Having controls at your finger tips during racing is an absolute must with today's technology and cars. However, it is a double edge sword with some combinations having up to 4 buttons. From Street Cars to Pro Mods, you often see 2, 3, 4 buttons on a steering wheel with cords that run towards the dash. The problem exists that when you remove the steering wheel and hang it up, or when you turn the steering wheel, these cords become tangled in each other, in the dash display mount, turn signal etc and that will rip the cords out of even the highest quality buttons. This product helps to alleviate these issues in several ways. By connecting the buttons via cords to a hard mounted connector on the steering wheel, we reduce the stresses and bend moments on the cords as they enter the buttons. This will all but remove possibilities for damage on the buttons themselves. For years we have been designing and testing a RELIABLE solution for multi cord and steering wheel button wiring. Trying to find the balance between durability, reliability, and cost effectiveness we have developed a mono cord design that solves every issue without sacrificing reliability as can be seen with cordless options (we spent time trying these as well). This kit is designed to work with both 5 and 6 bolt steering wheels or quick release connections. We have verified fitment with the following quick releases: Strange (as included in Motion Raceworks columns, Mark Williams, MPI). By removing multiple cords and having one point of contact and one cord, you will no longer need to worry about not only the unsightliness of multiple cords, but getting tangled, wrapped, and torn as a result. This single cord can be fixed anywhere further down the column or dash in order to create the necessary slack needed to avoid tangling and wrapping around items