Product Information:
Power supply: 5V
Size: 9cm*7.5cm*20cm
Power: 1-3W
Shaft size: 13cm*4cm*1.6cm
Speed: 3000-6000Rpm
Uses: DIY hobbies / teaching experiments, etc..
With 5V power supply, the power supply is stable and
does not heat for a long time.
The 3-point magnetic levitation mechanism has a suction magnet
at both ends, and the jitter is almost invisible to the naked eye.
And the glass piece is added, it will not cause any abrasion to the acrylic,
suitable for long-term operation.

Instructions:
This product consists of 3 parts: data line / rotor / base
1. First plug one end of the data cable into the base
2. Place the rotor from top to bottom and place it in the position of two round glass pieces.
3. Connect the other end of the data cable to the 5V charger/mobile power
4. Turn on the switch

Note:
1. Do not touch the rotor during high speed operation! Do not use magnets or iron near the equipment!
2. Need to be placed on a horizontally prohibited desktop! Do not shake!
3. If the magnet is loose, tighten the screw and energize it!