【Installation Method】Attach the welding point to the spoiler and trim any excess material from the headlight. After fitting, hold it in place for a while to allow it to heat up normally before making any adjustments. Finally, install the light control plug into the third channel of the receiver
【3-Modes Adjustments】A three-channel control module is included, allowing for remote control of different modes as needed: flashing light; breathing light; long lighting
【Specification】Color: Red; Applicable Voltage: 5V-8.4V; Length: 50cm/19.68 inch
【Non-destructive Installation】 Requires only adhesive for application; no screws are needed, ensuring that the RC vehicle body and accessories remain undamaged
【High Brightness】The tail lamp is very bright, supporting your RC car driving at night
【Eye-Catching Simulation】Innovative attention-grabbing lighting effects will make your RC car stand out as the center of attention
【Easy to Install】No complicated installation steps are necessary; however, a certain level of hands-on skill is required
【What you get】1 * RC car tail light strip, 1* three-channel control module
【Note】Please be careful not to connect the positive and negative terminals in reverse
وصف
ZRRC RC COB Led Light Strip Taillights for 1/7th Arrma Limitless F1 Infraction Felony 6S Remote Control Adhesive Rear Lamp RC Car Upgrades Decoration
أجزاء ترقية قضيب التأرجح الأمامي/الخلفي من RCMYou من الألومنيوم لـ 1/10 Slash 2WD، وشريط التأرجح الأمامي/الخلفي المصنوع من سبيكة لـ 1/10 Slash 2WD
KWD 7
بطارية جهاز الاستقبال الذكي Spektrum 7.4V 2000mAh 2S 15C LiPo: جهاز الاستقبال العالمي، IC3، SPMX20002SRX
KWD 16
أداة/أداة إزالة عجلات 1.9/2.2 بوصة RC Beadlock تناسب 1/10 Traxxas TRX4 TRX6 الزاحف المحوري SCX10 Capra Redcat Beadlock Hub عجلة (لون رائع)
KWD 5
محولات عجلة محاور سداسية من الألومنيوم 12 مم وصواميل قفل ذات حواف M4، بسمك 5.5 مم و7.0 مم، لسيارة 1/10 2WD Traxxas Stampede Slash Rustler RC، استبدل 1654 3654 (أخضر)
KWD 4
