The TS2000 thin-kerf 3/32˝ blades remove 25% less material for EASIER CUTTING with minimum power table saw machines. Designed with specially engineered clearances on the carbide teeth that eliminate side scoring. The end result…no planing/jointing or sanding. In most cases a glue-line cut can be obtained, depending on the accuracy of the saw machine The TS2000 thin kerf saw blade are ground from C4 micro grain carbide, and go through a four step shaping and sharpening process. This process finishes with a 1200 grit pass to create razor sharp edges. These blades can be re-sharpened 20 - 25 times because of their increased thickness of the carbide. Low cost blades have a .010” radial or side clearance to keep irregular teeth from rubbing on the sides of the cut. Our blades are so accurate that the radial clearance is reduced to a mere .001” which dramatically improves the smoothness of the finished cut.