This QWIIC connector and cable allows you to easily connect QWIIC enabled modules to a Raspberry Pi, without the need for soldering. This QWIIC connector allows you to easily connect QWIIC enabled modules to a Raspberry Pi, without the need for soldering.

It uses a 2x3 pin female header which sits on top of the first 6 GPIO pins and breaks out the 3.3v, GND and the two I2C pins (SDA, SCL) on a 4 pin JST connector which sits on top.

This works nicely with the BerryIMU and BerryGPS-IMU.

The cable is 7.87" / 20cm in length, with a JST connector at each end.

Included in this purchase;
1 x QWIIC connector 1 x QWIIC cable
Raspberry Pi and BerryIMU are not included.