الاجهزه الالكترونيات الامريكية قد تحتاج الى محمول فولت من ١١٠ الى ٢٢٠.قد تحتاج إلى محول كهرباء
مميزات خاصة
[High Performance] Broadband, Low noise, Good flatness in the 1-6 GHz range. Gain: 21dB, OP1dB: 18dBm Typ. Supply Current: 80mA Off-chip bias, user can adjust the bias resistor to reduce the current
[USB Interface Powered] ZK06-UM is USB interface powered RF low noise amplifier with convenient power supply interface, moderate gain, high IP3 and low noise. Can be used to replace QPL9503, QPL9504 modules
[Reduce Noise Floor] Powered by USB type-C interface, and the built-in high PSRR LDO can effectively reduce the power noise, which effectively reduces the noise floor compared with other vendor's USB direct-feed modules
[Application] Recommended for use as tinySA ULTRA 5.8GHz preamplifier. Since the LNA in tinySA ULTRA is effective only below 3.5GHz, adding an LNA can enhance high-frequency sensitivity. ZK06-UM is helpful for users requiring measurements at 5.8GHz
[Note 1]Unless specifically requested, please avoid using both the built-in LNA and external LNA of tinySA ULTRA at the same time
[Note] The ZK06-UM LNA module has a very compact design and uses a system shield case, which may rust if exposed to moisture. Please pay attention to moisture protection when using outdoors
وصف
ZKxx-UM Series - USB Interface Powered RF Low Noise Amplifier
The ZK06-UM LNA Modules is USB interface powered RF low noise amplifier with convenient power supply interface, moderate gain, high IP3 and low noise.
The ZK06-UM is powered by USB type-C interface, and the built-in high PSRR LDO can effectively reduce the power noise, which effectively reduces the noise floor compared with other vendor's USB direct-feed modules.
Specifications:
1. Item Type: LNA Low Noice Amplifier
2. Module Frequency Range: 10M-6GHz (Good flatness in the 1-6 GHz range)
3. Gain: 21dB
4. OP1dB: 18dBm Typ
5. Power Supply: USB Interface Type-C
6. Supply Current: 80mA Off-chip bias, user can adjust the bias resistor to reduce the current
7. Recommended for use as tinySA ULTRA 5.8GHz preamplifier
8. Can be used to replace QPL9503, QPL9504 modules