WARNING: Your Factory wheel studs may extend past the surface of the wheel spacers. In this case you will need to:
1) Shorten the factory studs
2) Purchase a set of shorter studs and replace them with the factory studs.
3) The back of your wheels need to have the open slots (cavities)(at least 2" width and 1/4" deep) between mounting holes for installation of these spacers.These cavities are NEEDED so that the lug nuts and wheel studs can sit in this pocket. Verify this before purchasing.
Compatible for:
Hon da

2003-2025 Accord (2013-2019 will meet a stock bolts stick out)
2006-2025 Civic
1995-2025 CR-V
1997-2001 Prelude
1998-2004 Odyssey
2003-2006 MDX
2003-2008 Pilot
2003-2011 Element
2010-2017 CR-Z
2013-2018 Jade

A cura

2005-2011 CSX
2001-2003 CL
2012-2022 ILX
1997-2001 Integra R
1999-2008 TL
2014-2019 TLX
2002-2006 RSX
2003-2014 TSX

Important Notes
- It's recommended that buyers take the proper measurements to ensure that by adding the spacer, their wheel/tire won't hit the fender or any other part of the vehicle.
- Buyer's need to measure the length of their vehicle's OEM/Factory wheel studs, to ensure it doesn't extend past the surface of the spacer
- Installation should only be performed by a trained professional.
- Make sure you get 6-8 FULL TURNS of the lug nuts before tightening
- Avoid using an impact wrench; improper usage may cause damage to components
- Check and re-torque all lug nuts after 25-50 miles of driving