Specification:
Chip: L298N
Logic voltage: 5V
Logic current 0mA-36mA
Maximum power: 25W
Drive voltage: 5V-35V
Drive current: 2A(For each DC motor)
Operating mode: Dual H-bridge driver (can drive 2 DC motors)
Reason 1: Use L298N for Main Chip

Application:
When your driver is 7V-12V, you can enable the on-board 5V logic supply. When using the on-board 5V power supply,
the + 5V power supply in the interface does not input voltage, but it can draw 5V voltage for external use.
Adjustment:
Torque down the screw until the tab was pulled tight against the heat sink, to prevent parts from overheating under high load.
NOTE: Suitable for DC motors in smaller projects, but not for prototyping. Not recommended for stepper motors.
There are two ways to turn the system back on:
1. flip the power switch on the back of the computer and wait for the power supply cap to discharge as the relay will reset without power.
2. after popping the hood and examining for faults, press the button on the relay.There is a red LED on this for power and a green LED to indicate the relay is activated, so you can be pretty sure what state this is in.
Package Included:
4 * L298N Motor Driver Controller