INSTALLATION:
If you have never removed or installed this switch,It is an easy 5 minute job.Carefully pry up the plastic switch cover or bezel, the switch is attached to it with screws and your door wiring is plugged into the switch with a tabbed gang wire clip.Pull out the clip without tugging on the wiring. You may need to depress a tab with a small screwdriver while doing this.Plug in new switch and test. Swap the cover onto the new switch and drop back in the door. Done!

Window button does not work processing method：

If the newly installed switch button does not work most likely because the vehicle still recognizes the old switch,the following operations are required.

1. Press the left front door button (is the button that controls the driver's seat window) down to the bottom and stay for 5~8 seconds. 
2. When the button is lowered for 5~8 seconds, please push the button up to the end and stay for 5~8 seconds,then turn off the vehicle and restart the vehicle to complete the match. 
Note: Please pay attention to the mating plug before installing the switch, and clean the excess dust.