Introduction
This breakout board is able to drive DC motor.
It uses a DRV8833CPWP chip which outputs the maximum 700mA current
There are 4 motor control modes: Forward / Reverse / Brake / Stop. And PWM supporting frequency is up to 100 kHz.
For wiring, the board breaks out all the pins with the 3PIN interface, so you can connect other sensors to the board using 3pin wire.
At the same time, a 3.3V and 5V voltage-regulated chip is integrated into the breakout board, which leads to a 3.3V and 5V power output interface.
The board also comes with a serial communication port to facilitate the connection of BT module.

Details display, wiring diagram and test code are offered on keyestudio wiki page.

Parameters
Input Voltage：DC 5-10.8V
Drive Partial Working Current：≤700mA

Features
Four motor control modes: Forward/Reverse /Brake /Stop.
Access to 3Pin headers connection
Integrated with 3.3V and 5V voltage-regulator chip
Comes with serial port communication pins

Packaging List
2 * KEYESTUDIO Motor Drive Breakout Board