Fitment:

Compatible with ACURA Models:
For MDX 2007-2013
For TSX 2007-2014
For RDX 2007-2012

Compatible with Honda Models:
For Pilot 2009-2015 alloy

Placement on Vehicle:
Left, Right, Front, Rear

Replacement:
42753-STK-A02, 42753-STK-A03, 42753STKA03, 42753-STK-A04 ,42753STKA04, 42753TL2A52, PMV-107G

Tips:
This tire pressure sensor has been programmed in advance, no need to reprogram, just trigger it with tpms scan tool
Please DO NOT attempt to start a sensor replacement job if your scan tool or OBD diagnostic tool cannot detect our sensor to display information such as Real ID, Pressure, Frequency，battery status

Auto Relearn:
Set tyre pressure
Start the engine
On dashboard, set the system into the relearn mode
Drive until the relearn is completed

Manual Relearn:
Engage parking brake and inflate all tires
set vehicle into the relearn mode
Use tool to activate the Left Front sensor
Repeat for RF/RR/LR tires
After activate for sensor. Relearn complete, the dashboard will show the info

OBDII RELEARN
OBDII connector is required
Confirm TPMS sensors are properly installed
Adjust tire pressures to placard value
Activate TPMS Tool on left front tire sidewall next to the valve stem
Repeat for RF/RR/LR tires (Spare)if required
Apply OBD connector to DLC
Turn ignition to ON, Press OK on TPMS Tool to transfer data to ECU
Disconnect OBD connector from DLC
Turn ignition to OFF then ON
Drive at 12 mph for up to 5 minutes

Note:
Remove the original tire pressure sensor and install the new one
After installation, please park the car and turn off the engine for about 20 minutes, and keep the remote control key 5 meters away from car
Then start the vehicle and keep it running at a rate of 25 km/h above for 5--10 minutes to match the TPMS sensor
If the outdoor temperature is below 0, the matching time may be longer, that is normal. Please wait patiently for the matching