Z-Uno is the first and only easy to use developer board that allows you to create your own Z-Wave device without deep knowledge of Z-Wave protocol or programming. Z-Uno is a mix of Z-Wave home automation radio protocol power and Arduino simplicity. Being inspired by Arduino project Z-Uno inherits all concepts of easy-to-use hardware and software solutions, keeping maximum flexibility. Z-Uno is a fully DIY product. It is made for those who are limited by existing choice of Z-Wave products and wants to extend their smart homes with more sensors and actuators: connect LEDs, buttons, switches, motors or any low voltage sensor including most of Arduino compatible sensors. Z-Uno programming is done by writing sketch in simplified C language and loaded into Z-Uno using Arduino IDE. Many examples and comprehensive tutorials will help you to make your own project. Z-Uno is the perfect companion for you RaZberry 7 gateway. Z-Uno is compatible with other controllers too: among them Fibaro Home Centre 2/3/Lite/Lite 2, Youbii Home, Vera Edge and Zipato Zipabox. HARDWARE SPECIFICATION: 40 kB Flash memory for your sketches 8 kB RAM 2 kB EEPROM Z-Wave RF transmitter at 9.6/40/100 kbps 26 GPIO, 15 are 5V tollerant, 5 are able to wakeup device from deep sleep 4 ADC 4 PWM 3UART 3 SPI 16interrupts 1I2C 2x16Bit timers, 1x32 bit timer (GPT) 1-Wire(software) 2 service LEDs 1 service button 1 user test LED CSEN interface for capacitive touch-buttons LDMA controller for fast data transfers 32Bit Cortex M4F @ 39Mhz CPU