Search "sleeve anchors" on youtube for install videos
Ideal for concrete, or masonry
Tighten hex nut no more then 6ft-lbs
Zinc plated steel
وصف
(1) Using a hammer drill and carbide tipped drill bit, drill a hole the same diameter
as the anchor diameter, and at least 1/2" to 1” deeper than the expected embedment.
(2) Clean out the hole of all debris.
(3) Set the nut flush with the top of the sleeve anchor.
(4) Insert the sleeve anchor through the fixture into the hole in the base material
until the washer and nut is tight against the fixture.
(5) Turn the nut until finger tight.
(6) Use a wrench to set the anchor by turning the nut three to four full turns
