Wiring Instructions: M+ and M- are motor drive signal pins (for connecting to a motor driver module). VCC and GND are power supply terminals for the motor encoder (supporting both 3.3V and 5V input). Pins A and B connect to MCU I/O ports (for the MCU to acquire encoder signals). Important Warning: Never connect encoder power pins (VCC/GND) or A/B signal pins to the motor drive terminals M+/M-. Incorrect wiring will permanently damage the encoder.
Metal shaft: suitable for TT motor tires and Mecanum wheels with dedicated couplings
وصف
Parameters:
Motor name: 3-wire hall speed measurement TT motor
Deceleration ratio 1: 48, Output: 150 RPM
Torque: 1.2 N.m
Drive voltage: 5V-12V (Recommend 6-9V)
Drive current: Rated current: 0.25A, Stall current: 0.6A
Speed comparison: Motor 7000±5%rpm, wheel shaft 155±5%rpm
Encoder type: Incremental hall AB phase encoder
Encoder line number: 3 line
Shaft: Metal
Gear: Half-metal
Size: 79.95x25.2x25.79mm
Weight: 40g
Case color: blue
6P cable length: 20cm
Metal shaft: suitable for TT motor tires and Mecanum wheels with dedicated couplings
The motor with a PH2.0 6P connector. Its body is slightly longer than standard TT motors due to the built-in encoder mounted at the rear end.
Wiring Instructions:
M+ and M- are motor drive signal pins (for connecting to a motor driver module).
VCC and GND are power supply terminals for the motor encoder (supporting both 3.3V and 5V input).
Pins A and B connect to MCU I/O ports (for the MCU to acquire encoder signals).
Important Warning: Never connect encoder power pins (VCC/GND) or A/B signal pins to the motor drive terminals M+/M-. Incorrect wiring will permanently damage the encoder.