Optimized Design for Small-Scale Crawlers: 1212 climbing esc and motor kit is optimized design for small-scale crawlers such as 1/24 1/18, this set up is phenomenal for 1/24 like the FMS or UDI (on the Scx24, but you do need to make some modifications and use either a motor adapter or new transmission) and up to the 1/18 TRX4M Hobby Plus CR18p and the Ascent18
Normal Operating Characteristics: Some noise at mid-throttle is normal for the 1212 Rc motor and esc combo due to its high-speed, open-rotor design. This does not indicate a defect
Ultra-Low-Speed Linear Control: 25A brushless ESC Provides ultra-low-speed linear control, enabling smooth and stable start-up from as low as 0.1 km/h. Built-in multiple protection mechanisms
Motor Installation Specifications: The mounting screw holes of the motor are 4 x M2 with distance 12.5mm or 9mm, and the panel screw hole can be locked into the depth of 3mm. Therefore, it is recommended to use M2 screws of appropriate specifications for installation. The specific installation situation can be determined according to the frame
Weight Compatibility: This outrunner brushless motor is going to work best with lighter rigs under 1000g and really shines with rigs around or under 500g
Brushless 25A ESC Performance: Fit for 2S -3S Lithium batteries to keep your rc car runs smoothly and powerful in low or high speed. Faster heat dissipation and long durability. 30% increase in low-speed torque, Powerful at low speeds and even stronger at high speeds
Selectable BEC Output Voltages: The BEC supports selectable output voltages of 6.0V, 7.4V, and 8.4V with a maximum output current of 3A. Hardware and software optimized for mini scale, compatible with chassis smaller than 1/24 scale