Clamp less Starting Harness for use with the Micro-Start SPORT and Original designs of XP-1 or XP-3 models ONLY! For the Clamp less Harness for the XP-10 or XP-10-HD, please see our AG-MSA-10B version. For the Newer designs of XP-1 and XP-3, see our AG-MSA-10TP.The Micro-Start Clamp less Harness was made so a rider or driver can easily jump-start their vehicle using just their Micro-Start without the need for jumper clamps, or having to remove the seat on your motorcycle. It is a 12-in (300mm) harness with ring terminals that connect directly to the battery while the other end can plug directly into your Micro-Start's jump-start port. It adds convenience and saves time if the situation arises when you have to jump-start your vehicle. No need to get out your Smart Clamps - just connect the Micro-Start directly to this harness and jump-start your vehicle! PLEASE NOTE: The Micro-Start is for jump-starting only through the jump start port. Never leave the Micro-Start connected to your vehicle's battery for longer than 30 seconds, or use in place of your regular battery in your vehicle. Do not try to charge the Micro-Start directly from your vehicle battery through the jump start port. Severe damage can result! Use only the provided chargers in the Micro-Start's kit to charge the Micro-Start!AG-MSA-10A HARNESS COMPATIBLE WITH:• SPORT• XP-1 (Original design; has single USB port)• XP-3 (Original design; has single USB port)The tip of this MSA-10A harness is an EC5 connector, compatible with the original Micro-Start XP-1 and XP-3 jumpstart port. (The New designs of XP-1 and XP-3 have thermal protection and you can see the pin hole in its harness connector tip; use MSA-10TP.)