Fitment:
This is a set of connector housings, seals, and crimp connectors for certain Ford electric power assisted steering racks (not pumps) used in various 2011 and up Ford cars and trucks. Features:

The main power terminals are designed for 4 mm2 to 16 mm2 wire roughly equivalent to 11 AWG to 5 AWG. The seals are the teal versions and are designed for wire with an outer diameter of 7.3 mm (0.29") - 8.3 mm ( 0.33"). Depending on the length of wire you need, 6 AWG wire with decent quality cross-linked polyethylene insulation (SGX, etc.) should fit fine depending on your supplier.

The data connector terminals are designed for 0.75 mm2 to 1.0 mm2 wire or 18 AWG to 20 AWG wire. The seal is a mat style seal built into the housing. Note that I disassembled the connector housing for the picture to show the seal; the housing is designed so that you do not have to disassemble it to insert the terminal and wire. The wire and terminal simply are pushed through the back of the housing and seal.
The EPAS rack is a popular swap part for the earlier S197 Mustangs because it eliminates the need for a power steering pump when swapping in a later Coyote motor. With these connectors you can build your own wiring loom to fit your car with no splices.

You will get the main power connector with two seals and terminals and the data connector and three terminals as shown in the pictures.

Easy installation.
Please check out the picture of the steering rack and connectors to make sure these will fit.