1. Single channel USB to serial / parallel ports with a variety of configurations.
2. Whole USB protocol handled on the chip, no USB specific firmware programming required.
3. USB 2.0 high-speed (480Mbits/Second) and full speed (12Mbits/Second) compatible.
4. Multi-protocol synchronous serial engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI (MASTER) or bit-bang) design.
5. UART data transfer rate up to 12Mbaud (RS232 data rate is limited by externalshifter).
6. USB to synchronous 245 parallel FIFO mode transfer up to 40 megabytes/second.
7. USB to asynchronous 245 fifo mode data transfer rate up to 8 megabytes per second.
8. Support for special half-duplex FT1248 interface with configurable width, bidirectional data bus (1, 2, 4 or 8 bit wide).
9. CPU - style FIFO interface mode simplifies CPU interface design.
10. Fast serial interface option.
11. 's royalty- Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
12. Adjustable receive buffer timeout.

Spec:
Condition: Brand New
Item Type: USB to JTAG UART/FIFO SPI/I2C Module
Typical Applications
Single chip USB to UART (RS232, RS422 or RS485)
USB to FIFO
USB to FT1248
USB to JTAG
USB to SPI
USB to I2C
USB to Bit-Bang
USB to Fast Serial Interface
USB to CPU target interface (as memory)

packing list:
1 x Module
3 x Pin Header