Application:
This machine is widely used in lab restorative profession, it is the necessary product for all kinds of plaster models grinding and shaping, the machine has ≥30 degrees of angle adjustment, which can make the plaster model trimming more perfect.
Parameters:
Voltage: 220V 50HZ / 110V 60HZ
Power:550W
Wheel Size: outer 250*inner 32mm
Speed: 2800r/min
Wheel: Diamond Disc Wheel
Instructions for use
1、Firstly install the four shock-absorbing feet of the plaster finishing machine, place the machine in a smooth position, and connect the power supply.
2、Connect the water inlet pipe with the faucet tightly to avoid falling off.
3、Place the downpipe smoothly without buckling, so as to avoid water in the machine memory, resulting in serious splashing when the machine is running.
4, start the power supply, observe the motor has no strange sound, sand rotation is smooth, if abnormal. If there is any abnormality, stop the machine immediately for maintenance.
5、Observe whether the water supply has the effect of removing dust and removing the plaster powder adhered on the sand piece, if the effect is not good, adjust the size of faucet opening and closing.
6、Adjustment of sanding angle is light and flexible, Notice:
1.Must clean the plaster debris left in the machine, so that the drainage is smooth.
2.Drainage pipe must not be warped, otherwise it will lead to poor drainage of water in the machine and serious splash when sanding
3.No water use, so as not to plaster the sand piece putty flat, affecting the use.
Pacakge listing:
Host *1
Power cord *1
Upper water pipe*1
Downpipe*1
Hose band *2
Wrench*1
Suction cup*4