This Lovejoy carbon steel single pin-and-block universal joint with bored hubs, set screw, and keyway is designed to connect two rotating shafts at angles up to 25 degrees. This universal joint compensates for angular misalignments and has a single joint configuration for high torsional stiffness and torque capacity. The hubs, center block, and pins are made of American Iron and Steel Institute (AISI) 1144 carbon steel for strength and durability, and the bored hubs fit onto shafts without the need for machining. The needle bearing design allows up to 6,000 RPM for applications with continuous high rotational speeds. Operating temperatures range from -30 to 212 degrees F. A set screw secures the joint into position on the shaft, and a keyway prevents the shaft from rotating in the joint hub. For optimal wear and extended life, boots (sold separately) are recommended, and boot retaining grooves are standard on this design. This universal joint provides a uniform speed ratio between driving and driven shafts, and is suitable for applications requiring moderate torque transmission, such as compressors, fans, machine tools, printing presses, and textile machinery. Universal joints (also called U-joints, universal couplings, Cardan joints, Hookes joints, or Hardy-Spicer joints) are used to transmit motion and rotational power, or torque, between two shafts that are offset at an angle. Most universal joints consist of two yokes and a middle assembly; the hub end of each yoke attaches to a shaft while the yoke ears attach to and pivot around the middle assembly to accommodate shaft misalignment. The type of middle assembly determines its usagepin and block joints are suitable for transmitting high torque, needle bearing joints are used to handle high rotational speeds, and ball and socket joints are used in applications requiring low backlash (play between moving parts)