How to Use:
① Remove the original handlebar
② Wet the inner hole of the left handlebar with soapy water, and the twisting amplitude should not be too large during installation
③ When installing the balance iron on the left handlebar, adjust the position of the balance iron to be slightly separated from the handlebar, and do not squeeze the handlebar when tightening the screw
④ In use, if the left handlebar slides on a steel pipe, remove the balance iron, and fix it with a few drops of glue from the end of the handlebar
⑤ Power cord, the red wire is connected to the positive pole, and the black wire is connected to the negative pole (not reversed)
⑥ When installing the left handlebar, the power cord should be left enough for rotation

Specifications:
Material: Plastic
Color: Black
Input Voltage: 12V DC
Power: 15-35W Adjustable
Length: 122mm/4.8""
Handlebar Length: left handlebar: 127mm; right handlebar: 137mm
Hole Diameter: 22mm/0.87""
Fitment: Fit for most 12V motorcycle or ATV with 22mm(7/8"") diameter handlebar

Package Included:
1 x Pair of Motorcycle Handlebar

NOTE:
1. Please note that the temperature can not be adjusted if the wire connected wrong.
2. Since the electric heating handles use a rubber integral forming process, don't over twist the left handle when installation. Doing so will cause the electric heating wires to shift.
3. As to the model with the balancer, the balancer should be spaced out of the handle in order to avoid squeezing the handle when installing the balancer. If the position of the balancer can't be adjusted, use a shim between the balancer and handle. Being too close to the handle will lead to abnormal damages, such as making it difficult to toggle the switch, the electric heating wires squeezed out of the handle and so on.
4. If the left handle slide on the steel tube, apply some glue to the inner bore of the left handle to fix it. Never apply the glue to the steel tube, because doing so will allow the glue to penetrate into the switch, and make it unable to be toggled. Bear in mind that the glue will be pushed along the bar and may pool if you use too much.