Specification:
Product Material: ABS
Compatible Controller Protocols:Protocol 2
Interface pin number: 5pin/6pin
Handle mounting size: 2.2cm/0.87in
Compatible Models: For XILUOP, for KUGOO M4, for KUGOO Pro, for VSETT, for Kaabo, for Dualtron

Packing List:
Electric Thumb Throttle*1

Fault Information Profile:
When the fault reporting symbol is flashing, short press ON/OFF key to adjust the display interface to the fault display interface, the numbers displayed under the interface correspond to the specific fault content as follows:
ERRO 1: Motor fault
ERRO 2: Rotor fault
ERRO 3: Controller failure
ERRO 4: Power failure brake
ERRO 5: Undervoltage protection
ERRO 6: Communication failure, the meter can not receive the output of the controller
ERRO 7: Communication failure, the controller does not receive the output of the meter

Key Function Introduction:
1. Under the state of power off, long press the power button to turn on the power, after power on, short press the “mode” button, the interface will switch between ODO, TRIP, V, A, E, TM
2. In the power-on state, long press the power button to turn off the power
3. Long press the power button and “mode” button to enter the parameter setting interface, short press the power button to switch the voltage parameter; short press the “mode” button to switch the speed parameter, the default speed is gear 3, can be switched from 1 to 3 gear cycle. After confirming the parameter modification, long press the power button and “mode” button to exit the parameter setting, shut down and restart to save the parameters, complete the modification

Caveats:
1. Before purchasing, please make sure that your electric scooter controller uses protocol 2, otherwise it can not be used!
2. The interface of this product has two kinds of 5pin and 6pin, please make sure before purchasing