Features:
New high-quality motorcycle heated hand grip.
Fits: most motorcycles, ATV, motorbike etc.
Power: DC 12V.
Color: black.
Pad dimensions: 90 x 87mm.
With a on/off switch and switch light.

Benefits:
Keep your hands warm in cold weather.
Quick warm up time, low power consumption and long working life.
Self-adhesive feature makes them Fits under your existing hand grips without any modifications.
Easy to install and operate, just need to wire this in to a positive wire from your ignition.
With a on/off switch, and all necessary bits and pieces to install these under your current handgrips.
If your bike doesn't have a battery, just need to locate the DC regulator.

Package included:
2 x Heated grip pads (with connection wires and on/off switch).
2 x Heat resistant covers.
1 x Heat resistant tape.

Installation:
1. Place the heat plate on the right position.
2. Wrap the heat plate around to the handlebars evenly，especially at the junction with the heating plate.
3. Put on the jacket tube and adjust the position,using a hot-air gun blowing outer sleeve shrinkage uniformity.
4. Mount the switch in the rod of the rear view mirror.
5. Connect the power line. Line Red and Line Black are not divided into positive and negative,but must installed in the line control by the key door.
6. Please note that The interface between wire and heating plate must be wrapped tightly by tape, the form which hot air gun blow tube should be symmetrical. Wiring instructions aren't included but you can find tutorials on the web and it should only take you 5 to 10 minutes to wire in. Alternatively, any mechanic or electrician would be able to help.