8.5W/mK Conductive Paste Thermal Pad Patch, 0.25mm Thickness Lightweight Phase-change Pad 1pc

Specification:
Color: Gray
Material: Silicone
Thickness: 0.25mm
Thermal conductivity: 8.5 W/m-k
Density: 2.8 (g/cm3)
Thermal impedance: 0.04 -cm2/W
Phase change temperature: Within 45
Storage method: Refrigerated storage
Size: 31x40mm, 40x40mm, 40x80mm, 80x80mm, 80x160mm (optional)
Weight: 10g

Introduction to usage:
1. Thoroughly clean the face of the chip and the contacts face of the radiator
2. Key points: If the face of the chip is to be attached, it must be cut to the same size as the chip, or even slightly smaller by 1 edge, with a solid edge and no overhang, in order to tear the film. If it is attached to the base of the heat sink, it is recommended that it be 1 circle larger than the chip for easy aiming, and do not cover uneven bumps. Only on a flat face can the film be easily torn! However, no matter which side you are sticking to, the edges should not be suspended. The next step is easy to operate. Irregular edges and suspended edges can proper to poor film tearing
3. Tear off 1 side of the release film and paste it onto the base of the radiator or the face of the chip (do not repeatedly knead the phase change film before use. If room temperature is too high, you can refrigerate it for ten minutes, making it easier to tear off the film after cooling)
4. Then evenly apply pressure on the entire face of the phase change sheet with your thumb to fully adhere the phase change sheet for the next step of film tearing
5. Tear off the other half of the release film. It is more convenient to use the freedom easy to tear adhesive aid, which can start from the corners, making it more convenient
6. Directly install and fasten the radiator, and immediately turn it on for use