Instrument setting function
Long press the up button and down button of the meter to enter the meter settings.
P01: Backlight brightness, level 1 is the darkest, level 3 is the brightest.
P02: mileage unit, 0: KM; 1: MILE.
P03: Voltage level: 24V, 36V, 48V
P04: Sleep time: 0, no sleep; other numbers are sleep time, range: 1-60; unit is minute.
PO5: PAS level: 0, 3-level mode: 1-level 2V, 2-level 3V, 3-level 4V1, 5-level mode: 1-level 2V, 2-level 2.5V, 3-level 3V, 4-level 3.5V, 5-level 4V
P06: wheel diameter: unit, inch; accuracy: 0.1.
P07: Number of speed measuring magnets: range: 1-100.
P08: Speed limit. Range: 0-50km/h, 50 means unlimited. No communication state (controlled by the meter): When the actual speed exceeds the speed we set, the meter will turn off the for PWM output; when it is lower than the speed we set, the meter will automatically turn on the for PWM output, and the driving speed is ±1km/h ; (Speed limit applies to PAS, not accelerator) Communication status (controlled by controller): The driving speed is consistent with the speed we set. Random error: ±1km/h. (Speed limits apply to PAS and Throttle) Note: These figures are based on KM. When changing KM to Mile, the speed value on the screen will automatically convert to the correct Miles, but if you don't change the speed limit setting from KM to Mile, it will be different from the actual speed limit in Mile.
P09: for 0 start, non-for 0 start setting, 0: for 0 start; 1: non-for 0 start.
P10: Driving mode setting 0: Power-assisted driving (turning handle is invalid). 1: Electric drive (driven by turning the handle, at this time the power-assisted gear is invalid). 2: Power-assisted drive and electric drive coexist at the same time.
P11: Assist sensitivity setting Range: 1-24.
P12: Power for BOOST start strength setting Range: 0-5.
P13: The type of power-assisted magnets is set to 5, 8, and 12 magnets, among which 5 and 8 are single Hall power sensors, and 12 is used for dual Hall power sensors.
P14: Current limit of the controller. The current is 12A. Range: 1-20A
P15: There is no such function.
P16: ODO reset setting Long press the up button for 5 seconds ODO reset
P17: 0: cruise not allowed, 1: cruise allowed; auto cruise optional (only valid for protocol 2)
P18: Display speed scale range: 50%~150%,
P19:0 enable 0:0,1:0
P20: 0: 2 protocol 1: 5 S protocol 2: backup 3: backup

Specification:
Material: ABS
Color: Black (As Pictures Show)
Weight: About 225g
Model: 5pin
Voltage: 24-60V

Package Includes:
1 x Bike LCD Display
1 x Adapter cable