مميزات خاصة

This product is used to measure the fluid dynamics of fluids passing through pipes, such as water, ethylene thinners, glycols, and other liquids that do not corrode copper.
This water flow switch is suitable for water treatment systems, central air conditioning, water cooling units, fire protection systems and other fields.When performing wiring, it is absolutely forbidden to adjust any screws other than micro switch terminals and grounding screws. And connecting the wire carefully.
This flow switch is made of high quality stainless steel, corrosion resistant and long service life.
Flow switches are typically used in locations that require interlocking or "cutting" protection.When the flow exceeds the set value, the fluid drives the blade and microswitch, and the SPDT contact can connect the circuit and disconnect other circuits.
Special grounding screws should be used for wiring, and the installation screws cannot be removed. The blade of the flow switch cannot contact the inner wall of the pipe and other regulating valves of the pipe, otherwise the switch cannot be reset normally.

وصف

Specification:
Condition: 100% new
Material: stainless steel and plastic
Weight: 518g / 18.3oz
Voltage: 6-380V
Interface Size: 1"
Control mode: palette
Maximum working pressure: 1.0mpa
Ambient temperature: 0C ~ 60C
Liquid temperature: -10c-100c (without freezing)
Micro Switch: Single Pole Double Shot (SPDT)
Contact life: 100,000 times
Micro switch electrical parameters: 220VAC, 15A.

Installation method:
1.Open the flow switch
2.The switch has been set to the minimum flow rate. Turn the adjustment screw counterclockwise to increase the flow setting value.
3. Press the lens to check if the micro switch can work normally. Excessive clockwise rotation of the adjusting screw may cause flow switch failure.
4. After installation, press the flow switch lever several times to check. If there is no "click" sound, turn the adjustment screw counterclockwise until the "click" sound is heard.
5.The lacquer seal adjustment screw is only used for the first time to adjust the state of the flow switch.
6.Observe three operating cycles to ensure that the switch and the system you are connected to are working properly and cover the switch cabinet quickly.

Package List:
1 × water flow switch
5 × pallet

Note:
1. It is absolutely forbidden to impact the key on the switch motherboard.
2.When performing wiring or debugging, cut off the power supply.

مرحبًا،

بحث

مميزات خاصة

وصف

منتجات شبيهه