🔴 Spindle 3/8" Arbor Hole for Baldor Lathe Motor Spindle 3-1/2" Long Friction Grip Set Left and Right

🟢 Baldor Tapered Spindles 3/8"
🟢 Set Of 2 Right and Left Hand
🟢 Friction Grip Fits Baldor Polishing Lathe
🟢 Baldor Dental Lathe Motors

🟢 The spindle is made to use with a Baldor Polishing motor.
🟢 Spindle fits 3/8" Polishing lathes and has an inside diameter that is tapered to fit on the tapered shaft of a Baldor Polishing motor.
🟢 These are specifically made to fit Baldor motor shafts since they are not straight, but have a slight taper.
🟢 Spindles are a friction fit, they are pushed onto the shaft of the Baldor motor, to properly secure them onto the shaft, lightly tap with a soft mallet or a piece of wood.
🟢 To remove, just use the screw-off spindle remover on the motor by simply unscrewing and turning it until the spindle is pushed off of the tapered shaft.
🟢 Spindles are made of cold rolled steel machined to close tolerances, made in the U.S.A.
🟢 Spindles have a 3/8" Tapered arbor hole to work on the Baldor Lathes with 3/8" shaft motors.
🟢 The spindle arbor hole has a slight tapered to fit and be held on the Baldor Motor.
🟢 Note: The spindle does not have tightening screws.

🔻 FEATURES: 🔻
🔹 Precision Quality
🔹 Machined - High Speed Lathe
🔹 Made from 3/4" Stock Material

🔻 SPECIFICATIONS: JETS Product # 1603-112370+1603-212370 🔻
🔸 Material: Cold Rolled Steel
🔸 Overall Length: 3-3/8" - 87mm
🔸 Spindle Body Length: 1-3/8" - 35mm
🔸 Spindle Tapered Length: 2" - 51mm
🔸 Arbor Hole: 3/8" Tapered Friction Grip to Shaft
🔸 Weight: 2.75oz. - 478gr