This AWD front left axle and hub bearing pairing is configured for vehicles using a 4‑bolt hub with ABS pickup and a driver‑side CV axle around 26.25 inches compressed length. The axle features a 27‑tooth inner spline and 29‑tooth outer spline to interface with the transaxle and the wheel hub, while the hub assembly uses a 4.5 inch bolt circle with a flange near 5.35 inches to match the knuckle and brake rotor fit. The set targets common late‑2000s compact crossover layouts and addresses frequent service symptoms such as clicking on turns, vibration under load, or wheel‑end growl. Replacement can be performed following standard procedures, including torquing strut‑to‑knuckle fasteners and the axle nut per service data and verifying ABS sensor routing. Always compare spline counts, axle length, hub bolt pattern, and sensor provision to the parts on the vehicle to ensure a correct match prior to installation.