This package pairs a center support bearing sized for a 1.574 inch inner diameter with a large‑pattern universal joint measuring roughly 4.188 inches across the caps and 1.188 inch cap diameter. The bearing's width near 0.866 inch and mounting center spacing around 6.7 inches align with typical crossmember brackets used in two‑piece shaft layouts. The joint uses an outside‑snap‑ring design and fits yokes cut for that pattern. Installation follows normal service methods, including pressing the bearing squarely into the carrier and installing the snap‑ring joint, then torquing all fasteners per service data and verifying phasing marks before reassembly. Compare the bearing bore, bracket spacing, and joint dimensions to the components on the vehicle to ensure a precise match.