Made to fit your gun, and it ships ready to wear. Every one is formed over our CNC-machined aluminum molds, cut for one gun and nothing else. The KYDEX picks up the mold surface exactly, so the inside is glass smooth and easy on your finish.

What the Plus Line adds
The claw comes installed, not in a bag for you to fit. It uses your belt to lever the grip in tight, so the gun prints less from the first time you put it on. The clip is spring steel instead of polymer, and it hooks on a gun belt and stays put.

Check two things before you order
Your gun and the fitment above have to be the same model. Ordering the wrong one is the most common mistake we see, so read it against your gun, not from memory.
Then check the light. No WML or Weapon Mounted Light unless the fitment names one. If it does, the shell is molded around the gun and light together and it will not hold the gun without that light on it.
Inside the waistband only, under an untucked shirt. Not an OWB rig. Cut for a slide-mounted red dot or RMR, open at the muzzle for threaded barrels and tall sights.

When it shows up
The gun should drop in clean, no forcing. Posi-Click Retention clicks when it seats, so you know it is secure without looking. Dial the retention in where you want it. If it is way too tight or way too loose, you have probably got the wrong model in your hand.

You will stop noticing it
Three ounces of .08 inch KYDEX, thin enough to vanish under a t-shirt. Trigger guard is fully covered, so nothing gets to the trigger while it is holstered. The sweat guard runs the full length of the slide, so the gun stays off your skin. Cant runs minus 5 to plus 20 degrees for appendix, strong side, hip, SOB or cross draw. Two screws set retention, and a Phillips is the only tool you need.

Specs: .08 inch KYDEX, 3 oz, 1.5 inch spring steel clip, claw installed, black oxide hardware, made in the USA.