0/1-10V LED Dimming Driver PWM Constant Voltage 1CH 36V 24V 12V 0 -10V Dimmer Controller 1 Channel 1-10V Signal Input LV-L
0/1-10V LED Dimming Driver
Model No.: LV-L
0-10V or 1-10V signal input/PWM Constant voltage output/Four PWM frequencies/Logarithmic or liner dimming/Push Dim
Features
1 channel 0/1-10V LED dimming driver with push-dim function.
1 channel 0/1-10V input, 1 channel PWM constant voltage output.
Logarithmic or linear dimming curve selectable.
PWM frequency 500Hz, 2kHz, 8kHz or 16kHz selectable.
Compatible with active or passive 0-10V, 1-10V dimmer,can solve the fluorescent lamp dimming system compatible with LED lighting
Over-heat / Over-load / Short circuit protection, recover automatically
Compatibility with T18,T18-1,KL 0-10V LED Dimmer.
Technical Parameters
Model Number: LSD-LV-L
0-10V or 1-10V signal input/PWM Constant voltage output/Four PWM frequencies/Logarithmic or liner dimming/Push Dim
Input voltage: 12-48VDC
Output voltage: 12-48VDC
Output current: 15A@12/24V;10A@36/48V
Output power: 180W@12V;360W@24V;360W@36V;480W@48V
Output type: Constant voltage
Input signal: 0/1-10V + Push Dim
Dimming range: 0 -100%
Dimming curve: Logarithmic or linear
PWM Frequency: 500Hz, 2kHz, 8kHz, 16kHz
Technical Parameters
Note:
The 0/1-10V input is operable via commercially available simple rotary wall switchs designed for 0/1-10V dimming equipment or from decicated system central dimming controllers.
Compliant with 0-10V, 1-10V, 10V PWM, RX(4 in 1).
We recommend the number of LED drivers connected to 0/1-10V dimmer does not exceed 50 pieces, the maximum length of the wires from dimmer to LED driver should be no more than 50 meters.
If the LED driver be used with Push-Dim interface prior to using the 0/1-10V interface, the 0/1-10 V signal should change over 10% to 0/1-10 V control.
Push Dim Function
The provided Push-Dim interface allows for a simple dimming method using commercially available non-latching (momentary) wall switchs.
Short press:
Turn on or off light.
Long press (1-6s):
Press and hold to step-less dimming,
With every other long press, the light level goes to the opposite direction.
Dimming memory:
Light returns to the previous dimming level when switched off and on again, even at power failure.
Synchronization:
If more than one controller are connected to the same push switch, do a long press for more than 10s,
then the system is synchronized and all lights in the group dim up to .
This means there is no need for any additional synchrony wire in larger installations.
We recommend the number of controllers connected to a push switch does not exceed 50 pieces,
The maximum length of the wires from push to controller should be no more than 50 meters.